Next Gen Electric Co. is based at 511 E Spring St, a few minutes from the courthouse square.
Monroe isn't a service area we drive out to — it's where we are. That matters here more than in most towns, because Monroe runs its own electric and gas utility, and knowing how the City handles meters, disconnects and gas connections is a local skill rather than a general one.
What we deal with locally.
What we do here
Everything below is available across Monroe and the rest of Walton County — homes, businesses and job sites, one licensed crew.
100A → 200A
More capacity for modern HVAC, EV charging and additions.
Panel
Including the Federal Pacific and Zinsco boxes common in older Monroe homes.
Breakers
Diagnosed before replaced — the cause first, then the part.
Inspection
Written photo reports for buyers, sellers, insurers and landlords.
Standby
Sized on a real load calculation, transfer switch always itemised.
Level 2
Load calculation first, and the cheap option shown before the expensive one.
Nearby
This is the single most useful thing to know about electrical work in Monroe, and it catches out contractors from outside the county regularly.
Inside the city limits, your power doesn't come from Georgia Power or Walton EMC. It comes from the City of Monroe. The Monroe Utilities Department is a full municipal provider — electric, natural gas, water and wastewater — run out of City Hall at 215 N. Broad Street, a few streets from our own office.
The City has been doing this a long time. The first electrical grid went in during the 1920s, and natural gas followed in the 1950s. That history is written into the housing stock: a lot of Monroe homes were wired in eras whose standards look very different from today's.
We'll work out which applies to your address before quoting, because it affects the timeline. If you're not sure yourself, look at who sends the bill.
It matters because service upgrades, meter work and new connections are scheduled with whoever owns the meter — and their lead times differ.
Downed line or live hazard? Call 911 first. For a City of Monroe outage, their 24-hour dispatch is 770-267-3429. For work on your side of the meter, that's us.
Older Monroe homes
Monroe carries nineteen of Walton County's twenty-seven National Register sites, including nine historic districts. For an electrician that isn't trivia — it's a map of where the old wiring is.
The Monroe and Walton Mills Historic District covers around 120 acres and 236 contributing buildings. The Monroe Cotton Mill went up from 1895 with brick walls sixteen inches thick; the Walton Cotton Mill followed in 1900–01. Around them sit the mill houses — small, densely built, and wired long after they were constructed.
These are the properties where we most often find knob-and-tube, two-wire ungrounded circuits, and three-prong outlets with no ground behind them. They're also where insurers ask the most questions.
The North Broad Street district runs to 55 acres and 56 contributing buildings. The commercial district around the 1883 courthouse — Second Empire, by Bruce & Morgan — takes in 33 more.
Work in these buildings has an extra constraint: what you're allowed to disturb. A rewire in a contributing building isn't just an electrical question, and we'd rather raise that at the walkthrough than halfway through.
If your Monroe home is in or near one of these districts, three things are worth knowing before you get quotes. Lath and plaster costs considerably more to open and repair than drywall. Access through attics and crawl spaces decides most of the price. And an inspection first is usually cheaper than guessing — it tells you whether you're facing a rewire or a panel.
Rewires, knob-and-tube removal, grounding corrections
Federal Pacific and Zinsco panel replacements
EV chargers, added circuits, recessed lighting
Lighting retrofits, tenant fit-outs, code corrections
Service upgrades from 100A to 200A
Surge protection and standby generators
If your Monroe property doesn't fit any of these, that's fine — it's a list of what's common, not what we're limited to.
Permits
Monroe sits in Walton County, so permitted electrical work here goes through the county building department. We pull the permit in our name, schedule the inspection and meet the inspector ourselves.
Keep every closed permit. In Monroe specifically, with so much older housing stock changing hands, buyers' inspectors and insurers ask for them more often than most places.
Response
Our van doesn't come from Atlanta or Athens. It comes from 511 E Spring Street, which for most Monroe addresses is a few minutes away.
That has practical consequences beyond convenience. We can look at a job the same week more often than not. We can come back for a punch-list item without it being a half-day round trip. And when a quote needs a second look before you decide, that's a short drive rather than a scheduling problem.
Monday to Friday, 8am to 5pm. Call or text 678-648-9886 and you'll speak to the people who'll actually turn up — not a call centre in another state routing your job to whoever's nearest.
We serve Loganville, Winder, Athens, Watkinsville, Lake Oconee, Good Hope, Social Circle and Walnut Grove as well. Those are genuine drives, and we're straight about that on each page — but Monroe is home.
FAQ
Inside the city limits it's the City of Monroe. The Monroe Utilities Department is a full municipal provider covering electric, natural gas, water and wastewater, run from City Hall at 215 N. Broad Street. Outside the city limits it's usually Walton EMC, and towards Social Circle you may be on Georgia Power. It matters for any job needing the meter pulled, because that's coordinated with whoever owns it.
For most work beyond simple fixture swaps, yes — through the Walton County building department. Service upgrades, panel replacements, new circuits, EV chargers, generators and rewires all require a permit and inspection. Replacing a light fitting, a ceiling fan or a single breaker on sound existing wiring generally doesn't. We pull the permit in our name and meet the inspector.
Practically, yes. Lath and plaster walls cost considerably more to open and repair than drywall, and what you're permitted to disturb in a contributing building is a separate question from the electrical one. We raise both at the walkthrough. Around the mill housing in particular we frequently find knob-and-tube and ungrounded two-wire circuits, so an inspection first is usually cheaper than guessing.
In many in-town locations, yes — Monroe's municipal utility supplies natural gas as well as electricity, so properties on the gas main can often avoid a propane tank entirely. That changes both the cost and the installation. Outside the city limits, propane is usually the answer. We check what's available at your address before quoting.
No. We're based at 511 E Spring St, so for most Monroe addresses we're a few minutes away. It also means we can usually look at a job sooner, and coming back for a small item afterwards isn't a half-day trip.
Yes. We cover residential, commercial and industrial under one licence — lighting retrofits, tenant fit-outs, code corrections and equipment circuits for businesses around the square and across the county. Work that would disrupt trading can be scheduled outside opening hours.
Reviews
Replace with real Google reviews before launch.
Nearby
Monroe is home, but we cover a good stretch of East Georgia around it.
Monroe, GA
Good Hope, GA
Loganville, GA
Winder, GA
Athens, GA
Watkinsville, GA
Lake Oconee, GA
Social Circle, GA
Walnut Grove, GA
511 E Spring St
Monroe, GA 30655
Monday–Friday
8:00am – 5:00pm
Ready when you are
A few minutes from most addresses in town, with the local knowledge that saves time on permits, meters and older houses.